LOA template AIDC Implementation Seminar 28th – 31st October 2014

LOA template AIDC Implementation Seminar 28th – 31st October 2014 Adam Watkin Airservices Australia

Presentation title Introduction The Global ICD contains sample “Letter of Agreement” templates This presentation provides a summary of their content Reference PAN ICD Appendix A (Also Appendix G AIDC ICD V3)

LOA template Include specific procedures: “The format of AIDC messages (List messages used e.g. ABI, PAC, CDN, CPL, ACP, REJ, MAC, LAM and LRM) are as defined by the Pan Regional (NAT and APAC) AIDC Interface Control Document (ICD) as amended from time to time, unless described otherwise in this LOA”

LOA template Include specific procedures: “List messages not supported (e.g. “EST, TOC, AOC messages are not supported”)”

LOA template Include specific procedures: “Acceptance of CPL or CDN message is approval of the flight’s profile and requires no further voice communication (i.e. NonStandard Altitudes, Block Altitudes, and Deviations)”

LOA template (Describe other procedures applicable to the use of AIDC for this LOA. Some examples are listed below) Example only. “Receipt of a MAC message must not be interpreted as meaning that the flight plan has been cancelled. Voice coordination must be conducted by the transferring controller to confirm the status of the flight” Example only. “Each facility should advise the other facility of any known equipment outage that affects AIDC. In the event of AIDC outage, voice communication procedures will apply”

LOA template List AIDC Messages supported For each message used describe when it will be sent by each ATS Unit under the parameter column and use the “Notes” column to describe other applicable information for the message use by each ATS Unit. The following data provides examples of the type of information that could be incorporated

LOA template Messages Parameter ABI ATSU1: Sends ABI approx. 80 minutes prior to boundary (73 min prior to the 50 nm expanded sector boundary). ATSU2: Sends ABI approx. 87 minutes prior to boundary (80 min prior to the 50 nm expanded sector boundary). (Note: An updated ABI will not be sent once a CPL has been sent.) Notes ATSU1 : ATSU2 Updated ABI’s will be sent automatically if there is any change to profile. ABI is sent automatically and is transparent to the controller. ABI automatically updates the receiving unit’s flight data record.

LOA template CPL ATSU1 : ATSU2 Send CPL messages approx 37 minutes prior to the boundary (30 minutes prior to the 50 nm expanded sector boundary). ATSU1 : ATSU2 CPL messages should be sent by the transferring controller in sufficient time to allow the completion of coordination at least 30 minutes prior to the boundary or 30 minutes prior to the aircraft passing within 50nmof the FIR boundary for information transfers.

LOA template CDN ATSU1 : ATSU2 CDN messages are sent by either the transferring or receiving facility to propose a change once the coordination process has been completed, i.e., CPL sent and ACP received. CDN’s must contain all applicable profile restrictions (e.g. weather deviations, speed assignment, block altitude). If the use of a CDN does not support this requirement, then verbal coordination is required. ATSU1 : ATSU2 The APS will display a flashing “DIA” until receipt of ACP. If ACPJ not received within ten (10) minutes, controller is alerted with a message to the queue. CDN messages are not normally used for coordination of reroutes; however, with the receiving facilities approval a CDN may be used to coordinate a reroute on a critical status aircraft such as in an emergency.

LOA template PAC ATSU1 : ATSU2 PAC messages will normally be sent when the time criteria from the departure point to the boundary is less than that stipulated in the CPL. ATSU1 : ATSU2 Will respond to a PAC message with an ACP. PAC messages should be verbally verified with receiving facility.

LOA template ACP ATSU1 : ATSU2 ATSU1 : ATSU2 The APS will display a flashing “DIA” until receipt of ACP. If ACP not received within ten (10) minutes, controller is alerted with a message to the queue.

LOA template TOC ATSU1 : ATSU2 Not supported. Implicit hand in/off. AOC ATSU1 : ATSU2 Not supported. Implicit hand in/off. ATSU1 : ATSU2

More information Adam Watkin Air Traffic Controller Brisbane Centre [email protected]